• If media other than the dedicated one is used, correct media feeding cannot be assured.
(6)The media veers during printing.
(7)Roll media is not cut well.
No. Possible cause Remedy Reference
1
Are you using the dedicated media? Use the dedicated media.
4.2.1 Media
2
Is the media used in a place other than
the specified environment?
Use the media in a dedicated environment.
4.2.2 Caution
s on handling
media
3
Using an old media? Replace it with new media.
5.1.2 Replacin
g roll media
3.4.3 Loading
sheet media
4
Using media with fold, wrinkle, etc?
5
Does the media curl or float? Use the dedicated media.
If media that is not dedicated is used, set the
following items in the MediaSet Menu.
• Media
• Stiffness
4.2.1 Media
4.5.1.2 Media
Set Menu
No. Possible cause Remedy Reference
1
Are you using the dedicated media? Use the dedicated media.
4.2.1 Media
2
Is the loading position of the media
correct?
Set the media correctly.
5.1.2 Replacin
g roll media
3.4.3 Loading
sheet media
3
Is the scroller set correctly? Set the scroller correctly.
3.4.1 Roll
media loading
No. Possible cause Remedy Reference
1
Does the razor blade cut well?
• Replace the cutter blade.
• To use the media other than specified,
make settings for the following items in
the Media setup menu.
4.5.1.2.1 When dedicated
media is set in Media item
5.1.3 Replacin
g razor blade
2
Is the roll media charged with static
electricity?
Remove the charged static electricity. -