• Pay attention to the following points while handling power supply plug. Any mishandling
of the power cable could cause a fire.
• Make sure that no foreign substances such as dust etc. are stuck to the power plug.
• The power plug is firmly inserted to the edge of the power socket.
• If the printer is not used for a longer period, make sure to pull out the power plug from the
power socket for safety.
• Make sure to connect an earth wire to the earth connection which meets the following
standards.
• Earth terminal of power socket
• Earth wire with copper plate which is buried at 650 mm or more, deep in the ground.
• Contact the retail outlet of purchase, when the earth connection cannot be established, or when the
earth connection is not given.
• Do not pull out the power cable from the power socket, while the power supply of the printer is ON.
Whenever the plug is pulled out from the power socket, allow one minute or more before inserting
the plug in the power socket again.
No. Name
1
Power plug
To Next Page
Loading...
Need help?
General