Before using VJ-1628X OPERATION MANUAL
42 3.1 Power cord set connection
3. Insert the plug of the power cord set firmly in the socket.
• Do not pull out or insert the power plug with a wet hand.
This could lead to an electric shock.
• Make sure to use only the specified power supply (AC 100 V to 120 V or AC 220 V to
240 V).
If a power supply other than the specified voltage is used, it could cause an electric
shock or fire.
• Take power for the printer directly from the power socket (AC 100 V to 120 V or AC
220 V to 240 V).
Do not use multiple plugs on the same socket.
This could generate heat and might cause a fire.
• Be sure to use a dedicated power socket with an earth wire for the power supply,
and connect it to the earth wire.
If the earth wire is not connected, it may cause an electric shock or fire.
• Do not connect an earth wire to the following places.
• Gas pipes
There is a possibility of ignition and explosion.
• An earth wire of telephone cables and lightning rods
A heavy current might flow whenever lightning strikes.
• Water pipe and faucet
The earth does not work if part of the metal pipe is plastic.
• Pay attention to the following points when handling the power plug.
Any mishandling of the power cable could cause a fire.
• Make sure that no foreign substances such as dust are stuck to the power plug.
• Make sure that the power plug is inserted all the way.
• When you do not use the printer for a long period, make sure to pull out the power
plug from the power socket for safety.
• Make sure to connect an earth wire to the earth connection that meets the following
standards.
• An earth terminal of power socket
• An earth wire with a copper plate which is buried at 650 mm or more in the ground.
To Next Page
Loading...
Need help?
General