Handling the printer VJ-1324X OPERATION MANUAL
118 4.2 Media
d. After the Confirm Print, the media is cut.
4.4.3 Cutting media
6. Measure the distance between the two pluses in the Confirm Print using a ruler.
Then, confirm that the distance matches the feeding length when printing.
a. If the distance does not match the feeding length, follow the procedure from Step 1 to Step 5 and
readjust.
b. If the distance matches the feeding length, proceed to step 7.
7. Perform Micro Print.
a. Display the Dist.Adj menu on the operation panel in the same way as in step 1.
b. Press the [+] key or [–] key on the operation panel to select “PF4: Micro Print”.
c. Press the [Enter] key on the operation panel.
• “Warming up Skip ->E” is displayed on Operation panel.
• While “Warming Up” is displayed, do not touch Platen and Media guide. They
become very hot and you could burn yourself.
• You can start printing during warming up.
4.4.7 Start Printing during Warm up
• “Printing” is displayed on Operation panel.
(The printer starts printing after warming up is complete.)
• Starts micro adjustment printing.
To Next Page
Loading...
