Maintenance VJ-1324X OPERATION MANUAL
204 6.1 Replacing consumable components
(3) Replacing steps
Follow the procedure below to replace the cutter.
1. If the printer is turned ON, make sure the following.
• Printing or other operations are not in progress.
• The operation panel display is Normal.
2. Display the CR Maintenance menu on the operation panel.
a. Press the [Menu] key on the operation panel.
• “Menu 1: Setup>” is displayed on the operation panel.
• The operation panel shifts to the Setup menu display.
b. Press the [>] key on the operation panel.
• “Set1: User Type” is displayed on the operation panel.
To Next Page
Loading...
Need help?
General