- 12 -
Maintenance
B
MAX
MIN
Switch on the engine for several minutes.
After switching off the engine, wait at least ten minutes
and then check the oil level.
Ensure that the motorcycle is placed on level ground
and is in a vertical position.
The correct level must be as close as possible to the
“MAX” mark shown on the engine casing. Do not sur-
pass this limit.
Check any oil leakages.
Avoid turning the engine over with the oil
level lower than minimum. It could compro-
mise the correct functioning of the engine.
If the level after the topping-up, is over the
“MAX” reference notch, correct it by emp-
tying a little oil out of the engine.
Oil pipes
During ordinary maintenance operations, ensure that
the different components are properly fitted and that no
oil is leaking from the parts involved in engine lubrica-
tion and in particular from:
– The crankcase.
– The oil feed pipes connecting the oil pump to the
cylinder head.
If even the slightest leakage is found, overhaul
the components as described in the F4 engine
workshop manual (Part No. 8000B4302).
To Next Page
Loading...
