Suspension and wheels
F
- 59 -
Unscrew shoulder bolt (2) until you can insert the chain
into the special tool. Position the chain breaker (1) so
that the ends of the chain pin can fit into the holes of
the hex nut and bolt (2).
Thread with the fingers the shoulder bolt (2) to put in
phase the chain with the tool.
1
2
Screw the bolt (1) until the pin is out of the chain plate
on the wheel side.
1
CHAIN REASSEMBLING (Regina 525 ZRPK)
Pick the new connecting link from the package.
The connecting link is supplied lubricated
with a special product that guarantees long
life. Absolutely avoid wiping away the lubri-
cant from the pin surfaces, as this would
seriously reduce the connecting links opera-
tional life.
This is particularly important for O-Ring
chains, as they cannot be re-lubricated.
Never reuse an old rivet link or old outer
plate previously disassembled from the
chain.
To Next Page
Loading...
