Brakes
- 11 -
H
Fill the system by pulling the front brake lever 3-4 times
(see figure).
Repeat the above operations until the fluid reaches the
minimum level in the reservoir. Top up with fresh fluid
and carry on with the operation until fluid of a different
colour (fresh) flows out.
The quantity of brake fluid necessary for this operation
is approximately 250 cc.
Repeat this operation on both calipers.
Recommended brake fluid: AGIP Brake 4
Utilise only the prescribed brake fluid from
sealed containers. NEVER use old or used
brake fluid.
Tighten the bleed screw, remove the rubber tube, care-
fully clean the screw with alcohol, blow it dry and put the
protective cap back on.
Bleed screw tightening torque: 8 Nm
NOTE
Perform the bleeding on the front brake pump in the same
way described for the front brake caliper.
Tighten the bleed screw, remove the rubber tube, care-
fully clean the screw with alcohol, blow it dry and put the
protective cap back on.
Bleed screw tightening torque: 12÷16 Nm
8 N•m
12÷16 N•m
To Next Page
Loading...
