Brakes
- 17 -
H
Put a thread-brake of the recommended type on the
first few threads of the locking screw (1).
Specific product: Loctite 243
Insert the fixing screw (1) into the corresponding
threaded hole and tighten the screw to the prescribed
torque pressure.
Torque pressure: 2 N•m
When refitting the float chamber, use a new
fixing screw.
To substitute the reservoir of the clutch pump,
operate exactly in the same way as the front
brake pump.
2 N•m
1
NOTE
NOTE
Thoroughly clean housing (1).
Fit O-ring (2) into its groove.
Use a new O-ring.
1
2
Place reservoir (1) in its housing (2).
Insert rubber separator (3).
2
1
3
NOTE
To Next Page
Loading...
