LAN Configuration
116
ProSecure Unified Threat Management (UTM) Appliance
Internet access, and you do not need to configure additional static routes. You should
configure static routes only for unusual cases such as multiple firewalls or multiple IP subnets
located on your network.
Note: The UTM automatically sets up routes between VLANs and
secondary IP addresses that you have configured on the LAN
Multi-homing screen (see Configure Multihome LAN IPs on the
Default VLAN on page 104). Therefore, you do not need to manually
add a static route between a VLAN and a secondary IP address.
Configure Static Routes
 To add a static route to the Static Route table:
1. Select Network Config > Routing. The Routing screen displays:
Figure 61.
2. Click the Add table button under the Static Routes table. The Add Static Route screen
displays:
Figure 62.
To Next Page
Loading...
Need help?
General
