Virtual Private Networking Using IPSec Connections
304
ProSecure Unified Threat Management (UTM) Appliance
2. Enter the settings as explained in the following table:
3. Click Apply to save your settings.
View the Active L2TP Users
 To view the active L2TP tunnel users:
Select Monitoring > Active Users & VPNs > L2TP Active Users. The L2TP Active Users
screen displays:
Figure 187.
Table 78. L2TP Server screen settings
Setting Description
L2TP Server
Enable L2TP Server To enable the L2TP server, select the Enable check box. Complete the following
fields:
Start IP Address Type the first IP address of the address pool.
End IP Address Type the last IP address of the address pool.
User time out Enter the time-out period in seconds. If there is no traffic
from a user, the connection is disconnected after the
specified period.
Authentication
Select one or more of the following authentication methods to authenticate L2TP users:
• PAP. RADIUS-Password Authentication Protocol (PAP).
• CHAP. RADIUS-Challenge Handshake Authentication Protocol (CHAP).
• MSCHAP. RADIUS-Microsoft CHAP (MSCHAP).
• MSCHAPv2. RADIUS-Microsoft CHAP version 2 (MSCHAPv2).
Note: For each authentication method that you want to use for L2TP users, you need to have created a
domain that supports the authentication method (see Configure Domains on page 353) and have added the
L2TP users to the domain (see Configure User Accounts on page 362).
To Next Page
Loading...
Need help?
General
