Managing Users, Authentication, and VPN Certificates
378
ProSecure Unified Threat Management (UTM) Appliance
for the minutes or hours. The idle time period cannot exceed the session expiration
length. By default, the idle time period is 8 hours.
3. Click Apply to save the session settings.
4. Locate the Users Portal Login Settings section on screen. Specify the default domain
settings:
• From the Default Domain drop-down list, select a domain that you previously
configured on the Domain screen (see Configure Domains on page 353). This domain
is presented on the User Portal Login screen (see Figure 209 on page 347). By
default, the domain that is presented is geardomain.
• Select the Authenticate User with User Selected Domain check box to limit the
authentication on the User Portal Login screen to the domain that you select from the
Default Domain drop-down list. If you do not select this check box, the UTM attempts
to authenticate users through all the domains that are listed in the drop-down list on
the User Portal Login screen. When authentication through one domain fails, the UTM
attempts authentication through another domain.
5. Click Apply to save the default domain settings.
View and Log Out Active Users
A user with administrative privileges can view the active users and log out selected or all
active users.
 To log out all active users:
1. Select Users > Active Users. The Active Users screen displays:
Figure 232.
2. Click the Logout All Users button in the gray settings bar at the top of the Active Users
screen.
To Next Page
Loading...
Need help?
General
