Firewall Protection
136
ProSecure Unified Threat Management (UTM) Appliance
Figure 70.
2. Enter the settings as explained in Table 28 on page 127.
3. Click Apply to save your changes. The new rule is now added to the Inbound Services
table.
Set LAN DMZ Rules
The LAN DMZ Rules screen allows you to create rules that define the movement of traffic
between the LAN and the DMZ. The default outbound and inbound policies are to block all
traffic between the local LAN and DMZ network. You can then apply firewall rules to allow
specific types of traffic either going out from the LAN to the DMZ (outbound) or coming in
from the DMZ to the LAN (inbound).
There is no drop-down list that lets you set the default outbound policy as there is on the LAN
WAN Rules screen. You can change the default outbound policy by allowing all outbound
traffic and then blocking specific services from passing through the UTM. You do so by
adding outbound service rules (see LAN DMZ Outbound Service Rules on page 137).
To access the LAN DMZ Rules screen and to make changes to an existing outbound or
inbound service rule, select Network Security > Firewall > LAN DMZ Rules. The LAN DMZ
Rules screen displays:
To Next Page
Loading...
Need help?
General
