Firewall Protection
135
ProSecure Unified Threat Management (UTM) Appliance
can block or allow traffic between the DMZ and any external WAN IP address according to
the schedule created in the Schedule screen.
 To create a new outbound DMZ WAN service rule:
1. In the DMZ WAN Rules screen, click the Add table button under the Outbound Services
table. The Add DMZ WAN Outbound Service screen displays:
Figure 69.
2. Enter the settings as explained in Table 27 on page 124.
3. Click Apply. The new rule is now added to the Outbound Services table. The rule is
automatically enabled.
DMZ WAN Inbound Service Rules
The Inbound Services table lists all existing rules for inbound traffic. If you have not defined
any rules, no rules are listed. By default, all inbound traffic (from the Internet to the DMZ) is
blocked.
Inbound rules that are configured on the LAN WAN Rules screen take precedence over
inbound rules that are configured on the DMZ WAN Rules screen. As a result, if an inbound
packet matches an inbound rule on the LAN WAN Rules screen, it is not matched against the
inbound rules on the DMZ WAN Rules screen.
 To create a new inbound DMZ WAN service rule:
1. In the DMZ WAN Rules screen, click the Add table button under the Inbound Services
table. The Add DMZ WAN Inbound Service screen displays:
To Next Page
Loading...
Need help?
General
