NETGEAR UTM9S Reference Manual

Firewall Protection
124
ProSecure Unified Threat Management (UTM) Appliance
The following table describes the fields that define the rules for outbound traffic and that are
common to most Outbound Service screens (see Figure 66 on page 132, Figure 69 on
page 135, and Figure 72 on page 138).
The steps to configure outbound rules are described in the following sections:
• Set LAN WAN Rules
• Set DMZ WAN Rules
• Set LAN DMZ Rules
Table 27. Outbound rules overview
Setting Description
Service The service or application to be covered by this rule. If the service or application does not
display in the list, you need to define it using the Services screen (see Add Customized
Services on page 152).
Action The action for outgoing connections covered by this rule:
• BLOCK always
• BLOCK by schedule, otherwise allow
• ALLOW always
• ALLOW by schedule, otherwise block
Note: Any outbound traffic that is not blocked by rules you create is allowed by the
default rule.
Note: ALLOW rules are useful only if the traffic is already covered by a BLOCK rule. That
is, you wish to allow a subset of traffic that is currently blocked by another rule.
Select Schedule The time schedule (that is, Schedule1, Schedule2, or Schedule3) that is used by this rule.
• This drop-down list is activated only when BLOCK by schedule, otherwise allow or
ALLOW by schedule, otherwise block is selected as the action.
• Use the Schedule screen to configure the time schedules (see Set a Schedule to Block
or Allow Specific Traffic on page 163).
LAN Users The settings that determine which computers on your network are affected by this rule.
The options are:
• Any. All PCs and devices on your LAN.
• Single address. Enter the required address in the Start field to apply the rule to a
single device on your LAN.
• Address range. Enter the required addresses in the Start and End fields to apply the
rule to a range of devices.
• Group. Select the LAN group to which the rule applies. Use the LAN Groups screen to
assign PCs to groups. See Manage Groups and Hosts (LAN Groups) on page 106.
• IP Group. Select the IP group to which the rule applies. Use the IP Groups screen to
assign IP addresses to groups. See Create IP Groups on page 156.

NETGEAR UTM9S Specifications

General

Brand	NETGEAR
Model	UTM9S
Category	Network Hardware
Language	English