Firewall Protection
133
ProSecure Unified Threat Management (UTM) Appliance
 To create a new inbound LAN WAN service rule:
1. In the LAN WAN Rules screen, click the Add table button under the Inbound Services
table. The Add LAN WAN Inbound Service screen displays:
Figure 67.
2. Enter the settings as explained in Table 28 on page 127.
3. Click Apply to save your changes. The new rule is now added to the Inbound Services
table.
Set DMZ WAN Rules
The firewall rules for traffic between the DMZ and the Internet are configured on the DMZ
WAN Rules screen. The default outbound policy is to block all traffic from and to the Internet.
You can then apply firewall rules to allow specific types of traffic either going out from the
DMZ to the Internet (outbound) or coming in from the Internet to the DMZ (inbound).
There is no drop-down list that lets you set the default outbound policy as there is on the LAN
WAN Rules screen. You can change the default outbound policy by enabling all outbound
traffic and then blocking only specific services from passing through the UTM. You do so by
adding outbound services rules (see DMZ WAN Outbound Service Rules on page 134).
To Next Page
Loading...
Need help?
General
