Firewall Protection
150
ProSecure Unified Threat Management (UTM) Appliance
 To delete one or more multicast source addresses:
1. In the Alternate Networks table, select the check box to the left of each address that you
want to delete, or click the Select All table button to select all addresses.
2. Click the Delete table button.
Set Session Limits
The session limits feature allows you to specify the total number of sessions that are allowed,
per user, over an IP connection across the UTM. The session limits feature is disabled by
default.
 To enable and configure session limits:
1. Select Network Security > Firewall > Session Limit. The Session Limit screen
displays:
Figure 83.
2. Select the Yes radio button under Do you want to enable Session Limit?
3. Enter the settings as explained in the following table:
Table 31. Session Limit screen settings
Setting Description
Session Limit
User Limit Parameter From the User Limit Parameter drop-down list, select one of the following options:
• Percentage of Max Sessions. A percentage of the total session connection
capacity of the UTM.
• Number of Sessions. An absolute number of maximum sessions.
To Next Page
Loading...
Need help?
General
