xDSL Module for the UTM9S
528
ProSecure Unified Threat Management (UTM) Appliance
5. Click Apply to save your changes.
Depending on the changes that you made, when you click Apply,
the UTM9S restarts, or services such as HTTP and SMTP might
restart.
Additional WAN-Related Configuration Tasks
• If you have not done so already, configure the WAN interfaces of the UTM9S (see
Chapter 3, Manually Configuring Internet and WAN Settings).
• If you want the ability to manage the UTM9S remotely, enable remote management (see
Configure Remote Management Access on page 399). If you enable remote
management, NETGEAR strongly recommend that you change your password (see
Change Passwords and Administrator and Guest Settings on page 397).
• You can set up the traffic meter for the DSL interface, if you wish. See Enable the WAN
Traffic Meter on page 419.
Use this MAC Address Select the Use this MAC Address radio button, and manually enter the MAC
address in the field next to the radio button. You would typically enter the MAC
address that your ISP is requiring for MAC authentication.
Note: The format for the MAC address is 01:23:45:67:89:AB (numbers
0–9 and either uppercase or lowercase letters A–F). If you enter a MAC
address, the existing entry is overwritten.
Failure Detection Method
See Configure the Failure Detection Method on page 516, including Table 134 on page 516.
Table 137. Advanced DSL settings (continued)
Setting Description
To Next Page
Loading...
Need help?
General
