Virtual Private Networking Using IPSec Connections
300
ProSecure Unified Threat Management (UTM) Appliance
2. In the List of VPN Policies table, click the Edit table button to the right of the VPN policy that
you want to edit. The Edit VPN Policy screen displays. (The following figure shows only the
top part of a UTM50 screen with the General section).
Figure 183.
3. Select the Enable NetBIOS check box.
4. Click Apply to save your settings.
Configure the PPTP Server (UTM9S Only)
As an alternate solution to IPSec VPN and L2TP tunnels, you can configure a Point-to-Point
Tunnel Protocol (PPTP) server on the UTM9S to allow users to access PPTP clients over
PPTP tunnels.
A PPTP user typically initiates a tunnel request; the PPTP server accommodates the tunnel
request and assigns an IP address to the user. After a PPTP tunnel is established, the user
can connect to a PPTP client that is located behind the UTM9S.
You need to enable the PPTP server on the UTM9S, specify a PPTP server address pool,
and create PPTP user accounts. For information about how to create PPTP user accounts,
see Configure User Accounts on page 362.
 To enable the PPTP server and configure the PPTP server pool, authentication, and
encryption:
1. Select VPN > PPTP Server. The PPTP Server screen displays:
To Next Page
Loading...
Need help?
General
