Virtual Private Networking Using IPSec Connections
301
ProSecure Unified Threat Management (UTM) Appliance
Figure 184.
2. Enter the settings as explained in the following table:
Table 76. PPTP Server screen settings
Setting Description
PPTP Server
Enable PPTP Server To enable the PPTP server, select the Enable check box. Complete the
following fields:
Start IP Address Type the first IP address of the address pool.
End IP Address Type the last IP address of the address pool.
User time out Enter the time-out period in seconds. If there is no traffic
from a user, the connection is disconnected after the
specified period.
Authentication
Select one or more of the following authentication methods to authenticate PPTP users:
• PAP. RADIUS-Password Authentication Protocol (PAP).
• CHAP. RADIUS-Challenge Handshake Authentication Protocol (CHAP).
• MSCHAP. RADIUS-Microsoft CHAP (MSCHAP).
• MSCHAPv2. RADIUS-Microsoft CHAP version 2 (MSCHAPv2).
Note: For each authentication method that you want to use for PPTP users, you need to have created a
domain that supports the authentication method (see Configure Domains on page 353) and have added the
PPTP users to the domain (see Configure User Accounts on page 362).
To Next Page
Loading...
Need help?
General
