xDSL Module for the UTM9S
526
ProSecure Unified Threat Management (UTM) Appliance
5. Configure the DDNS service settings for the DSL interface as explained in the following
table:
6. Click Apply to save your configuration.
Configure Advanced WAN Options
The advanced options include configuring the maximum transmission unit (MTU) size, the
port speed, and the UTM9S’s MAC address, and setting a rate limit on the traffic that is being
forwarded by the UTM9S.
Note: You can also configure the failure detection method for the
auto-rollover mode on the Advanced screen. This procedure is
discussed in Configure the Failure Detection Method on page 516.
 To configure advanced WAN options:
1. Select Network Config > WAN Settings.
2. Click the Edit button in the Action column of the SLOT-x entry. The SLOT-x ISP Settings
screen displays (see Figure 298 on page 506, which shows the SLOT-2 ISP Settings screen
as an example).
Table 136. DNS service settings
Setting Description
SLOT-x (Dynamic DNS Status: ...)
Change DNS to
(DynDNS, TZO,
Oray, or 3322)
Select the Yes radio button to enable the DDNS service. The fields that display on the
screen depend on the DDNS service provider that you have selected. Enter the following
settings:
Host and Domain Name The host and domain name for the DDNS service.
Username or
User Email Address
The user name or email address for DDNS server
authentication.
Password or User Key The password that is used for DDNS server authentication.
Use wildcards If your DDNS provider allows the use of wildcards in resolving
your URL, you can select the Use wildcards check box to
activate this feature. For example, the wildcard feature
causes *.yourhost.dyndns.org to be aliased to the same IP
address as yourhost.dyndns.org.
Update every 30 days If your WAN IP address does not change often, you might
need to force a periodic update to the DDNS service to
prevent your account from expiring. If the Update every 30
days check box displays, select it to enable a periodic
update.