Virtual Private Networking Using IPSec Connections
240
ProSecure Unified Threat Management (UTM) Appliance
 To set up a gateway-to-gateway VPN tunnel using the VPN Wizard:
1. Select VPN > IPSec VPN > VPN Wizard. The VPN Wizard screen displays (see the
following figure, which shows the VPN Wizard screen for the UTM50, and contains an
example).
The Connection Name and Remote IP Type section of the VPN Wizard screen shows the
following minor differences for the various UTM models:
• Single WAN port models. No WAN selection drop-down list.
• Multiple WAN port models. A drop-down list to select the WAN interface, a check box
to enable VPN rollover, and another drop-down list to select a WAN interface for VPN
rollover. If the multiple WAN port model is configured to function in WAN auto-rollover
mode, you can use the VPN Wizard to configure VPN rollover and do not need to
configure this manually.
Figure 137.
To view the wizard default settings, click the VPN Wizard Default Values option arrow in
the upper right of the screen. A pop-up screen displays (see the following figure), showing
the wizard default values. After you have completed the wizard, you can modify these
settings for the tunnel policy that you have set up.
To Next Page
Loading...
Need help?
General
