NETGEAR UTM9S

Virtual Private Networking Using IPSec Connections
251
ProSecure Unified Threat Management (UTM) Appliance
Figure 149.
b. Specify the default lifetimes in seconds:
• Authentication (IKE), Default. The default lifetime value is 3600 seconds.
Change this setting to 28800 seconds to match the configuration of the UTM.
• Encryption (IPSec), Default. The default lifetime value is 1200 seconds. Change
this setting to 3600 seconds to match the configuration of the UTM.
8. Click Apply to use the new settings immediately, and click Save to keep the settings for
future use.
The VPN client configuration is now complete.
Instead of using the wizard on the VPN client, you can also manually configure the VPN
client, which is explained in the following section.
Manually Create a Secure Connection Using the NETGEAR VPN Client
Note: Perform these tasks from a PC that has the NETGEAR ProSafe
VPN Client installed.
To manually configure a VPN connection between the VPN client and the UTM, create
authentication settings (phase 1 settings), create an associated IPSec configuration (phase 2
settings), and then specify the global parameters.