Network and System Management
400
ProSecure Unified Threat Management (UTM) Appliance
If you are remotely connected to the UTM and you select the No
radio button, you and all other SSL VPN users are disconnected
when you click Apply.
3. As an option, you can change the default HTTPS port. The default port number is 443.
4. Click Apply to save your changes.
When remote management is enabled, you need to use an SSL connection to access the
UTM from the Internet. You need to enter https:// (not http://) and type the UTM’s WAN IP
address in your browser. For example, if the UTM’s WAN IP address is 10.16.0.123, type the
following in your browser: https://10.16.0.123.
The UTM’s remote login URL is:
https://<IP_address> or https://<FullyQualifiedDomainName>
Note: For enhanced security, restrict access to as few external IP
addresses as practical. See Set User Login Policies on page 365 for
instructions on restricting administrator access by IP address.
Note: To maintain security, the UTM rejects a login that uses http://address
rather than the SSL https://address.
Note: The first time that you remotely connect to the UTM with a browser
through an SSL connection, you might get a warning message
regarding the SSL certificate. If you are using a Windows computer
with Internet Explorer 5.5 or later, simply click Yes to accept the
certificate.
Note: If you are unable to remotely connect to the UTM after enabling
HTTPS remote management, check if other user policies, such as
the default user policy, are preventing access. For access to the
UTM’s web management interface, check if administrative access
through a WAN interface is granted (see Configure Login Policies on
page 365).
To Next Page
Loading...
Need help?
General
