Monitoring System Access and Performance
459
ProSecure Unified Threat Management (UTM) Appliance
meaningful name). If the PC or device was assigned an IP address by the DHCP
server, then the name is appended by an asterisk.
• IP Address. The current IP address of the PC or device. For DHCP clients of the
UTM, this IP address does not change. If a PC or device is assigned a static IP
address, you need to update this entry manually after the IP address on the PC or
device has changed.
• MAC Address. The MAC address of the PC or device’s network interface.
• Group. Each PC or device can be assigned to a single LAN group. By default, a PC
or device is assigned to Group 1. You can select a different LAN group from the
Group drop-down list in the Add Known PCs and Devices section or on the Edit
Groups and Hosts screen.
• Action. The Edit table button, which provides access to the Edit Groups and Hosts
screen.
Note: If the UTM is rebooted, the data in the Known PCs and Devices
table is lost until the UTM rediscovers the devices.
View the DHCP Log
Note: There is no separate DHCP log on the UTM9S. To view the DHCP
entries on the UTM9S, query the system logs (see Query the Logs
on page 460).
 To review the most recent entries in the DHCP log:
1. Select Network Config > LAN Settings. The LAN Settings submenu tabs display, with
the LAN Setup screen in view (see Figure 275 on page 458).
2. Click the DHCP Log option arrow in the upper right of the LAN Setup screen. The DHCP
Log displays in a pop-up screen:
Figure 277.
To Next Page
Loading...
Need help?
General
