NETGEAR UTM9S

xDSL Module for the UTM9S
509
ProSecure Unified Threat Management (UTM) Appliance
3. Locate the ISP Login section on the screen:
Figure 301.
In the ISP Login section, select one of the following options:
• If your ISP requires an initial login to establish an Internet connection, select Yes.
(The default is No.)
• If a login is not required, select No, and ignore the Login and Password fields.
4. If you selected Yes, enter the login name in the Login field and the password in the
Password field. This information is provided by your ISP.
5. In the ISP Type section of the screen, select the type of ISP connection that you use from
the two listed options. By default, PPPoE is selected, as shown in the following figure:
Figure 302.
6. If your connection is Point-to-Point Protocol over Ethernet (PPPoE) or Point-to-Point
Protocol over ATM (PPPoA), your ISP requires an initial login. Enter the settings as
explained in the following table:
Table 131. PPPoE and PPPoA settings
Setting Description
PPPoE If your ISP uses PPPoE for login, select this radio button, and enter the following settings:
Account Name The account name for the PPPoE connection.
Domain Name The name of your ISP’s domain or your domain name if your ISP has
assigned you one. You can leave this field blank.