xDSL Module for the UTM9S
511
ProSecure Unified Threat Management (UTM) Appliance
8. In the Domain Name Server (DNS) Servers section of the screen (see the following figure),
specify the DNS settings as explained in the following table.
Figure 303.
Table 132. Internet IP address settings
Setting Description
Get Dynamically
from ISP
If your ISP has not assigned you a static IP address, select the Get Dynamically from
ISP radio button. The ISP automatically assigns an IP address to the UTM9S using
DHCP network protocol.
Use Static IP
Address
If your ISP has assigned you a fixed (static or permanent) IP address, select the Use
Static IP Address radio button, and enter the following settings:
IP Address Static IP address assigned to you. This address identifies the
UTM9S to your ISP.
Subnet Mask The subnet mask is usually provided by your ISP.
Gateway IP Address The IP address of the ISP’s gateway is usually provided by
your ISP.
Use IP Over
ATM (IPOA)
If your ISP uses IP over ATM (IPoA), select the Use IP Over ATM (IPOA) radio button,
and enter the following settings:
IP Address The IP address assigned to you. This address identifies the
UTM9S to your ISP.
Subnet Mask The subnet mask is usually provided by your ISP.
Gateway IP Address The IP address of the ISP’s gateway is usually provided by
your ISP.
Table 133. DNS server settings
Setting Description
Get Automatically
from ISP
If your ISP has not assigned any Domain Name Server (DNS) addresses, select the
Get Automatically from ISP radio button.
To Next Page
Loading...
Need help?
General
