NETGEAR UTM9S Reference Manual

Using the Setup Wizard to Provision the UTM in Your Network
54
ProSecure Unified Threat Management (UTM) Appliance
Enter the settings as explained in the following table, and then click Next to go the following
screen.
Table 8. Setup Wizard Step 5: Email Security screen settings
Setting Description
Action
SMTP From the SMTP drop-down list, select one of the following actions to be taken when
an infected email is detected:
• Block infected email. This is the default setting. The email is blocked, and a log
entry is created.
• Delete attachment. The email is not blocked, but the attachment is deleted, and
a log entry is created.
• Log only. Only a log entry is created. The email is not blocked, and the
attachment is not deleted.
• Quarantine attachment (UTM9S only). The email is not blocked, but the
attachment is quarantined on a ReadyNAS, and a log entry is created (see the
Note on page 176).
• Quarantine infected email (UTM9S only). The email is quarantined on a
ReadyNAS, and a log entry is created (see the Note on page 176).
POP3 From the POP3 drop-down list, select one of the following actions to be taken when
an infected email is detected:
• Delete attachment. This is the default setting. The email is not blocked, but the
attachment is deleted, and a log entry is created.
• Log only. Only a log entry is created. The email is not blocked, and the
attachment is not deleted.
• Quarantine attachment (UTM9S only). The email is not blocked, but the
attachment is quarantined on a ReadyNAS, and a log entry is created (see the
Note on page 176).
IMAP From the IMAP drop-down list, select one of the following actions to be taken when
an infected email is detected:
• Delete attachment. This is the default setting. The email is not blocked, but the
attachment is deleted, and a log entry is created.
• Log only. Only a log entry is created. The email is not blocked, and the
attachment is not deleted.
• Quarantine attachment (UTM9S only). The email is not blocked, but the
attachment is quarantined on a ReadyNAS, and a log entry is created (see the
Note on page 176).
Scan Exceptions
The default maximum size of the file or message that is scanned is 2048 KB, but you can define a maximum
size of up to 10240 KB. However, setting the maximum size to a high value might affect the UTM’s performance
(see Performance Management on page 389).
From the drop-down list, select one of the following actions to be taken when the file or message exceeds the
maximum size:
• Skip. The file is not scanned but skipped, leaving the end user vulnerable. This is the default setting.
• Block. The file is blocked and does not reach the end user.

NETGEAR UTM9S Specifications

General

Brand	NETGEAR
Model	UTM9S
Category	Network Hardware
Language	English