Wireless Module for the UTM9S
555
ProSecure Unified Threat Management (UTM) Appliance
 To test for wireless connectivity:
1. Configure the 802.11b/g/n or 802.11a/n wireless clients so that they all have the same
SSID that you have configured on the wireless access point. Make sure that the
wireless mode on the wireless access point supports the wireless capacity of the
wireless clients. (For example, 802.11b-compliant devices cannot connect to the
wireless access point if the wireless mode is set to ng.)
2. Verify that your wireless clients have a link to the wireless access point. If you have
enabled the DHCP server on the UTM9S (see Configure a VLAN Profile on page 98) and
have assigned a VLAN to the wireless access point, verify that your wireless clients are
able to obtain an IP address through DHCP from the UTM9S.
3. Verify network connectivity by using a browser such as Internet Explorer 6.0 or later or
Mozilla Firefox 1.5 or later to browse the Internet, or check for file and printer access on your
network.
If you have trouble connecting to the wireless module, try to connect without security by
selecting OPEN from the Security drop-down list on the Edit Profiles screen. If that does not
help you to solve the connection problem, see Chapter 12, Troubleshooting and Using Online
Support.
To Next Page
Loading...
Need help?
General
