Configure Switching
136
XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual
7. In the Protocol field, enter one or more protocols that must be associated with the group.
You can enter keywords such as arp, ip, and ipx. Separate keywords with a comma. You
can also enter hexadecimal or decimal values in the range of 0x0600 (1536) to 0xFFFF
(65535).
8. In the VLAN ID field, enter the VLAN ID.
The ID can be any number in the range of 1 to 4093. All the ports in the group assign this
VLAN ID to untagged packets received for the protocols that you included in this group.
9. Click the Add button.
The protocol-based VLAN group is added to the switch.
10. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
The following table describes the nonconfigurable information displayed on the page.
Configure Protocol-Based VLAN Group Membership
To configure protocol-based VLAN group membership:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching> VLAN > Advanced > Protocol Based VLAN Group Membership.
Table 33. Protocol Based VLAN Group Configuration information
Field Description
Group ID A number used to identify the group created by the user. Group IDs are
automatically assigned when a group is created by the user.
Ports Display all the member ports that belong to the group.