Specifications and Default Settings
439
XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual
System Setup and Maintenance Settings
The following table describes the system setup and maintenance settings.
Port Characteristics
The following table describes the port characteristics.
Auto-VoIP, OUI-Based
Admin Mode Disabled
Auto-VoIP VLAN 2
OUI-based priority 7
Table 97. System setup and maintenance settings
Feature Sets Supported Default
Boot code update 1 N/A
DHCP/manual IP 1 DHCP enabled/192.168.0.239
System name configuration 1 NULL
Configuration save/restore 1 N/A
Firmware upgrade 1 N/A
Restore defaults 1 (web and front-panel button) N/A
Dual image support 1 Enabled
Factory reset 1 N/A
Table 98. Port characteristics
Feature Sets Supported Default
Auto negotiating speed and
full/half duplex
All ports Auto negotiation
Auto MDI/MDIX for cross over cables on all ports Enabled
802.3x flow control/back pressure 1 (per system) Disabled
Port mirroring: TX, RX, Both 1 Disabled
Port trunking (aggregation) 8 Preconfigured
Table 96. General feature default settings (continued)
Feature Name/Setting Default