NETGEAR XS708T

Maintenance
408
XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual
14. From the Source menu, select the IP address or interface that must be used to send echo
request packets:
• None. The source address for the traceroute is the address of the default egress
interface.
• IP Address. The source IP address that must be used for the traceroute. With this
selection, the IPv6 Address field displays and you must enter the IPv6 address that
must be used as the source.
• Interface. The interface that must be used for the traceroute. With this selection, the
Interface menu displays and you must select an interface as the source.
15. Click the Apply button.
A traceroute request is sent to the specified IP address or host name. The results are
displayed below the configurable data in the Results field.
Remote Diagnostics
Use the Remote Diagnostics page to enable or disable the option to access the switch
remotely to perform diagnostics services.
 To enable remote diagnostics:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Maintenance > Troubleshooting > Remote Diagnostics.
The Remote Diagnostics page displays.
6. Select the Enable radio button.
7. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.