Manage Device Security
284
XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Security > Access > HTTPS > HTTPS Configuration.
6. Select the HTTPS Admin Mode Enable or Disable radio button.
This enables or disables the administrative mode of secure HTTP (HTTPS). The
configured value is displayed. The default value is Disable. You can download SSL
certificates only when the HTTPS admin mode is disabled. HTTPS admin mode can be
enabled only if a certificate is present on the device.
7. Select the SSL Version 3 Enable or Disable radio button.
This enables or disables Secure Sockets Layer version 3.0. The configured value is
displayed. The default value is Enable.
8. Select the TLS Version 1 Enable or Disable radio button.
This enables or disables Transport Layer Security version 1.0. The configured value is
displayed. The default value is Enable.
9. In the HTTPS Port field, type the HTTPS port number.
The value must be in the range of 1025 to 65535. Port 443 is the default value. The
configured value is displayed.
10. In the HTTPS Session Soft Timeout (Minutes) field, enter the inactivity time-out for HTTPS
sessions.
The value must be in the range of 1 to 60 minutes. The default value is 5 minutes. The
configured value is displayed.
11. In the HTTPS Session Hard Timeout (Hours) field, set the hard time-out for HTTPS
sessions.
This time-out is unaffected by the activity level of the session. The value must be in the
range of 1 to 168 hours. The default value is 24 hours.