7705 SAR Interfaces
118
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Notes:
1. Refers to the 6-port SAR-M Ethernet module.
2. Not supported on Fast Ethernet ports.
3. If the port is in network mode, the unshaped-if-cir command can be configured but does not take
effect. If the port is in hybrid mode, the command takes effect.
Table 14 Port Command Applicability for LAG Configurations on Mixed-Generation
Hardware
CLI Command Gen-1 Port Gen-2 Port Gen-2 Port
on Module
1
Gen-3 Port Configuration Behavior
unshaped-if-cir
Supported
2
Supported
2
Supported
2
Supported
3
Allowed on Gen-1, Gen-2, and Gen-3 hardware, but
not on Fast Ethernet ports. All port members of the
same LAG must have the same value.
unshaped-sap-cir N/A Supported Supported N/A Allowed on Gen-2 and Gen-3 hardware, but not on
Gen-1 hardware. This means LAGs with Gen-1
members and Gen-2 or Gen-3 members do not allow
the unshaped-sap-cir command to be configured to a
non-zero value on Gen-2 or Gen-3 ports.
LAGs with Gen-2 and Gen-3 members are allowed if
all member ports have the same unshaped-sap-cir
value. Change the value only on the primary member.
The value is propagated to all other members.
shaper-policy N/A Supported Supported Supported Allowed on Gen-2 and Gen-3 hardware, but not on
Gen-1 hardware. The same restrictions described
above for the unshaped-sap-cir command for LAG
members apply.
cbs Supported Supported Supported Supported Allowed on all hardware generations. All LAG
members must have the same value. Change the
value only on the primary member. The value is
propagated to all other members.
src-pause Enable or
disable
Enable or
disable
Disable Enable or
disable
Allowed to change enable/disable on Gen-1, Gen-2,
and Gen-3 hardware, except for a Gen-3 port on a
6-port SAR-M Ethernet Module, where only the no
src-pause command is supported and cannot be
changed. All LAG members must have same value.
Change the value only on the primary member. The
value is propagated to all other members.
include-fcs N/A Enable or
disable
Always
enabled
Enable or
disable
Allowed on Gen-2 and Gen-3 hardware, but not on
Gen-1 hardware. The same restrictions described
above for the unshaped-sap-cir command for LAG
members apply.
scheduler-mode
(for port)
Profile or
4-priority
16-priority 16-priority 4-priority Allowed to configure per-port independently, whether
the port is a standalone or an active/standby member.
There is no propagation among ports within the same
LAG.
To Next Page
Loading...
