Nokia 7705 SAR - Page 211

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 211
config>port# aps
config>port>aps# switching-mode uni-1plus1
config>port>aps# working-circuit 1/2/4
config>port>aps# rdi-alarms circuit
config>port>aps# revert-time 5
config>port>aps# protect-circuit 1/3/4
Use the config port info command to display port configuration information.
ALU-B>config>port# info
-------------------------------------------------
shutdown
aps
switching-mode uni-1plus1
revert-time 5
working-circuit 1/2/4
protect-circuit 1/3/4
exit
sonet-sdh
exit
-------------------------------------------------
Use the following CLI syntax to configure APS port parameters for an MC-APS
group.
CLI Syntax: config# port aps-id
aps
advertise-interval advertise-interval
hold-time hold-time
neighbor ip-address
protect-circuit port-id
rdi-alarms {suppress | circuit}
revert-time minutes
working-circuit port-id
The following CLI syntax shows an example of configuring an MC-APS working
circuit on a node. The only mandatory configuration required to create an MC-APS
group is to configure the working and protection circuit, and the neighbor address.
Example: config# port aps-2
config>port# aps
config>port>aps# advertise-interval 25
config>port>aps# hold-time 75
config>port>aps# working-circuit 1/2/4
config>port>aps# neighbor 10.10.10.101
config>port>aps# rdi-alarms circuit
config>port>aps# revert-time 5