EasyManua.ls Logo

Nokia 7705 SAR - Page 375

Nokia 7705 SAR
902 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 375
On the 7705 SAR-H, 7705 SAR-Hc, and 6-port SAR-M Ethernet module, a PoE-capable port
can be configured for PoE and PoE+. On the 7705 SAR-W and 7705 SAR-Wx, a PoE-
capable port only supports PoE+ and can only be enabled using the poe plus command.
On the 7705 SAR-H, before a port can be configured for either PoE or PoE+, the PoE power
source option must first be configured as either internal or external using the
config>system>poe-power-source command; refer to the 7705 SAR Basic System
Configuration Guide, “System Command Reference”, for information.
When the 7705 SAR-H is configured for the internal power source option, PoE capability is
allowed on ports 5 and 6 only. Port 5 can be configured for PoE+ but in that case, port 6
cannot support PoE. When the system is configured for the external power source option, a
mix of PoE and PoE+ is allowed on ports 5, 6, 7, and 8. PoE+ is supported only on ports 5
and 7. Table 26 describes the allowed mix of PoE and PoE+ ports on the 7705 SAR-H.
On the 6-port SAR-M Ethernet module, ports 5 and 6 on the module can each support PoE.
Port 5 can also support PoE+, but if it is configured for PoE+, then port 6 cannot support PoE
power.
On the 7705 SAR-Hc, ports 5 and 6 each support PoE and PoE+. If configured for PoE, both
ports can be used for PoE simultaneously. Both ports are also capable of supporting PoE+
but not simultaneously; if one port is configured for PoE+, the other port can only be
configured for PoE. Ports 5 and 6 can also operate in non-PoE mode.
On the 7705 SAR-W, ports 4 and 5 support PoE+. Both ports can operate in non-PoE+ mode.
On the 7705 SAR-Wx, port 5 (the RJ-45 port labeled PoE) supports PoE+. The port can also
operate in non-PoE+ mode.
To disable PoE/PoE+ on a port and prevent it from delivering power, use the no form of the
command. Performing a shutdown command on the port does not disable PoE/PoE+ on the
port.
Default n/a
Table 26 Supported PoE/PoE+ Combinations on the 7705 SAR-H
PoE Power Supply
Source
Port 5 Port 6 Port 7 Port 8 Supported PoE/PoE+
Combinations
Internal PoE PoE No PoE No PoE Two PoE ports
Internal PoE+ No PoE No PoE No PoE One PoE+ port
External PoE PoE PoE PoE Four PoE ports
External PoE PoE PoE+ PoE Three PoE ports and one
PoE+ port
External PoE+ No PoE PoE+ PoE One PoE port and two
PoE+ ports

Table of Contents

Related product manuals