7705 SAR Interfaces
390
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
quiet-period
Syntax quiet-period seconds
no quiet-period
Context config>port>ethernet>dot1x
Description This command configures the time between two authentication sessions during which no
EAPOL frames are sent by the 7705 SAR. The timer is started after sending an EAP-Failure
message or after expiry of the supplicant timeout timer.
The no form of this command returns the value to the default.
Default 60
Parameters seconds — specifies the quiet period in seconds
Values 1 to 3600
radius-plcy
Syntax radius-plcy name
no radius-plcy
Context config>port>ethernet>dot1x
Description This command configures the RADIUS policy to be used for 802.1x authentication. An 802.1x
RADIUS policy must be configured (under config>system>security>dot1x) before it can be
associated with a port. If the RADIUS policy ID does not exist, an error is returned. Only one
802.1x RADIUS policy can be associated with a port at a time.
The no form of this command removes the RADIUS policy association.
Default no radius-plcy
Parameters name — specifies an existing 802.1x RADIUS policy name
re-auth-period
Syntax re-auth-period seconds
no re-auth-period
Context config>port>ethernet>dot1x
Description This command configures the number of seconds the system will wait before performing
reauthentication. This value is only relevant if reauthentication is enabled with the re-
authentication command.
The no form of this command returns the value to the default.
To Next Page
Loading...
