7705 SAR Interfaces
416
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
s-bit-signaling
Syntax s-bit-signaling {on | off}
Context config>port>serial>rs232
config>port>serial>x21
Description This command configures the S-bit signaling option on the RS-232 or X.21 interface.
For RS-232 interfaces only, if multi-drop is configured as slave or master, the system
automatically turns S-bit signaling off. The signaling mode cannot then be changed. If multi-
drop is configured as disabled, the system automatically turns S-bit signaling on. When multi-
drop is in disabled mode, S-bit signaling can be turned off or on.
This command is only valid for ports configured for subrate speeds.
Default on
Parameters on — enables S-bit signaling
off — disables S-bit signaling
socket
Syntax [no] socket socket-id
Context config>port>serial>rs232
Description This command creates a socket on an RS-232 port. When a socket is configured, the RS-232
channel-group command is blocked. If the port is already configured as a channel group
before the socket is configured, this command is blocked.
The no form of the command deletes the socket from the serial port.
Default n/a
Parameters socket-id — specifies the raw socket ID number
Values 1
encap-type
Syntax encap-type encap-type
Context config>port>serial>rs232>socket
Description This command specifies the encapsulation type for a socket. When the encapsulation type is
set, then the socket is considered operational and the port can be further configured as an
IP transport subservice under an IES or VPRN service.
To Next Page
Loading...
