Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 417
If the serial port has already been configured as an IES or VPRN IP transport subservice, then
this command is blocked until the IP transport subservice is deconfigured.
Default raw
Parameters encap-type — specifies the encapsulation type to be used with the socket
Values raw
rx
Syntax rx
Context config>port>serial>rs232>socket
Description This command enables the context to configure parameters for data packets received over a
serial port’s raw socket.
eop
Syntax eop
Context config>port>serial>rs232>socket>rx
Description This command enables the context to configure end-of-packet (EOP) parameters for data
packets received over the socket.
idle-timeout
Syntax idle-timeout milliseconds
Context config>port>serial>rs232>socket>rx>eop
Description This command specifies how long that a serial port can remain idle before an end of packet
is declared and the packet is sent over the socket.
Default 50 ms
Parameters time — specifies the length of time, in milliseconds, that a queued packet can remain idle
before an end of packet is declared
Values 10 to 5000
Note: An end of packet will be declared by whichever EOP condition is encountered first.
To Next Page
Loading...
