7705 SAR Interfaces
418
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
length
Syntax length bytes
Context config>port>serial>rs232>socket>rx>eop
Description This command specifies the number of characters (converted to bytes) received on the serial
port that triggers the node to encapsulate the characters in an IP transport packet and send
it over an IES or VPRN service.
Default 1500
Parameters bytes — the number of characters (in bytes) to trigger sending an IP transport packet
Values 1 to 1500
special-char
Syntax special-char value
no special-char
Context config>port>serial>rs232>socket>rx>eop
Description This command specifies a special character that, if received on the serial port, declares end
of packet and triggers the node to encapsulate previously received queued characters into
an IP transport packet and send it over an IES or VPRN service.
The no form of the command disables checking for a special character.
Default no special-char
Parameters value — specifies the special character, in a decimal or hexadecimal format, that triggers
end of packet
Values 0 to 255, or 0x00 to 0xFF
squelch-delay
Syntax squelch-delay seconds
no squelch-delay
Context config>port>serial>rs232>socket>rx
Note: Other than declaring the end of packet, the special character is otherwise treated as
regular data; that is, it is added to the packet.
To Next Page
Loading...
