Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 421
V.35 interfaces support speeds from 64 kb/s to 1920 kb/s. V.35 interfaces do not support
subrate speeds.
Rates of 56000 b/s and greater are valid only if the device-mode is set to synchronous.
Default 9600 (RS-232)
64k (X.21 and V.35)
Parameters 600 — sets the link speed to 600 b/s
1200 — sets the link speed to 1200 b/s
2400 — sets the link speed to 2400 b/s
4800 — sets the link speed to 4800 b/s
9600 — sets the link speed to 9600 b/s
19200 — sets the link speed to 19 200 b/s
38400 — sets the link speed to 38 400 b/s
56000 — sets the link speed to 56 000 b/s (not supported on RS-232 raw sockets)
57600 — sets the link speed to 57 600 b/s (supported on RS-232 raw sockets only)
115200 — sets the link speed to 115 200 b/s (supported on RS-232 raw sockets only)
64k — sets the link speed to 64 kb/s
128k — sets the link speed to 128 kb/s
256k — sets the link speed to 256 kb/s
384k — sets the link speed to 384 kb/s
512k — sets the link speed to 512 kb/s
640k — sets the link speed to 640 kb/s
768k — sets the link speed to 768 kb/s
896k — sets the link speed to 896 kb/s
1024k — sets the link speed to 1024 kb/s
1152k — sets the link speed to 1152 kb/s
1280k — sets the link speed to 1280 kb/s
1408k — sets the link speed to 1408 kb/s
1536k — sets the link speed to 1536 kb/s
1664k — sets the link speed to 1664 kb/s
1792k — sets the link speed to 1792 kb/s
1920k — sets the link speed to 1920 kb/s
To Next Page
Loading...
