7705 SAR Interfaces
422
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
stop-bits
Syntax stop-bits {1 | 2}
Context config>port>serial>rs232
config>port>serial>x21
Description This command configures the number of stop bits used to signify the end of a character.
This command is valid only if the device-mode is asynchronous.
This command cannot have a value of 2 if the character-length value is 8 and the parity value
is anything other than no parity (that is, anything other than none).
Default 1
Parameters 1 — specifies one stop bit in a character
2 — specifies two stop bits in a character
To Next Page
Loading...
