Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 449
The following lists the cards, modules, and platforms that support IMA groups and the number
of channel groups on the network and/or access side that can be bound to an IMA group:
• T1/E1 ports on the 7705 SAR-M (variants with T1/E1 ports)
IMA: 16
The following must have all member links of an IMA bundle configured on the same card
or module:
− 16-port T1/E1 ASAP Adapter card
IMA: 16
− 32-port T1/E1 ASAP Adapter card
IMA: 16
The following must have all member links of an IMA bundle configured on the same card
or module, and on the same port:
− 2-port OC3/STM1 Channelized Adapter card
IMA: 8
The no form of this command removes the specified channel group from the multilink bundle.
Default n/a
Parameters port-id — the physical port ID
Syntax: slot/mda/port.channel
minimum-links
Syntax minimum-links minimum-links
no minimum-links
Context config>port>multilink-bundle
Description This command sets the minimum number of links that must be active for the bundle to be
active.
If the number of active links drops below the configured minimum, then the multilink bundle
will transition to an operationally down state.
The no form of this command removes the minimum link limit.
Default 1
Parameters minimum-links — the minimum link limit, expressed as an integer
Values
MLPP Bundles IMA Bundles
Access Network Access
T1/E1 ports on the 7705 SAR-A (variants with
T1/E1 ports)
1 to 8 1 to 8 —
To Next Page
Loading...
