7705 SAR Interfaces
462
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
The no form of this command disables logging of the specified alarm.
Default ais for codir
rai for tpif
Parameters ais — reports alarm indication signal errors (configurable for codir only)
los — reports loss of signal errors
rai — reports remote alarm indication signal errors (configurable for tpif only)
timing-8k
Syntax [no] timing-8k
Context config>port>tdm>codir
Description This command enables generation of an 8-kHz signal on a codirectional interface.
Default disabled
ds1
Syntax [no] ds1 ds1-id
Context config>port>tdm
Description This command enables the context to configure DS1 frame parameters on a channelized
16-port T1/E1 ASAP Adapter card, 32-port T1/E1 ASAP Adapter card, 2-port OC3/STM1
Channelized Adapter card, 4-port OC3/STM1 / 1-port OC12/STM4 Adapter card, or 4-port
DS3/E3 Adapter card (DS3 ports only).
T1 transmits DS1-formatted data at 1.544 Mb/s through the network.
Once a channel has been configured for DS1, all ports on the card can only be configured for
DS1. There cannot be a mix of DS1 and E1 channels on the same card.
The no form of this command deletes the specified DS1 channel.
Default n/a
Parameters ds1-id — the identifier of the DS1 channel
Values DS1 number (1 to 28) | ds1-sonet-sdh-index
To Next Page
Loading...
