Nokia 7705 SAR - Page 461

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 461
mode
Syntax mode access
Context config>port>tdm>codir>channel-group
config>port>tdm>tpif>channel-group
Description This command configures the interface for access mode. An access port or channel is used
for customer-facing traffic. A Service Access Point (SAP) can only be configured on an
access port or channel. When an interface is configured for access mode, the appropriate
encapsulation type must be specified.
Default access
Parameters access — configures the port as service access
loopback
Syntax loopback {internal | line}
no loopback
Context config>port>tdm>codir
config>port>tdm>tpif
Description This command puts the specified interface into a loopback mode. The port must be shut down
before loopback mode is enabled.
This command is not saved in the system configuration between boots.
The no form of this command disables the loopback on the interface.
Default no loopback
Parameters internal — places the port or channel into an internal loopback mode. An internal
loopback loops the frames from the local router back to the framer.
line — places the port or channel into a line loopback mode. A line loopback loops data
received on the port or channel back to the remote end.
report-alarm
Syntax report-alarm {ais | los | rai}
no report-alarm
Context config>port>tdm>codir
config>port>tdm>tpif
Description This command enables logging of codirectional and TPIF alarms for the specified interface
or channel.