7705 SAR Interfaces
488
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Parameters mdl-string — specifies an MDL message up to 38 characters long
eic — specifies the equipment ID code up to 10 characters long
lic — specifies the line ID code up to 11 characters long
fic — specifies the frame ID code up to 10 characters long
unit — specifies the unit ID code up to 6 characters long
pfi — specifies the facility ID code up to 38 characters long
port — specifies the port ID code up to 38 characters long
gen — specifies the generator number to send in the MDL test signal message, up to 38
characters long
mdl-transmit
Syntax [no] mdl-transmit {path | idle-signal | test-signal}
Context config>port>tdm>ds3
Description This command enables the transmission of an MDL message on a DS3 port or channel. This
command is only applicable if the DS3 port or channel is using C-bit framing, specified using
the framing (DS3) command.
The no form of this command prevents the transmission of an MDL message on the DS3 port
or channel.
Default no mdl-transmit
Parameters path — specifies the MDL path message
idle-signal — specifies the MDL idle signal message
test-signal — specifies the MDL test signal message
mode
Syntax mode {access | network}
no mode
Context config>port>tdm>ds3
config>port>tdm>e3
Description This command configures a DS3/E3 port for access or network mode of operation.
SAPs can only be configured on access ports. When a DS3/E3 port is configured for access
mode, the encap-type can be set to atm, cem, or frame-relay.
To Next Page
Loading...
