7705 SAR Interfaces
522
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
vcb
Syntax vcb
Context config>scada
Description This command enables the context to configure voice conference bridge parameters for a
SCADA bridge.
idle-code
Syntax idle-code abcd-code
no idle-code
Context config>scada>vcb
Description This command defines the ABCD signaling code to be transmitted when the E&M interface
is configured to transmit idle fault signaling (see fault-signaling).
The no form of the command reverts to the default value.
This command is supported only when VCB is operating in vcb-branch-initiate mode.
Default 0 (for Mu-Law companding)
13 (for A-Law companding)
Parameters abcd-code — the 4-bit ABCD value to be transmitted
Values 0 to 15 (can be entered in decimal, binary, or hexadecimal format)
seized-code
Syntax seized-code abcd-code
no seized-code
Context config>scada>vcb
Description This command defines the ABCD signaling code to be transmitted when the E&M interface
is configured to transmit seized fault signaling (see fault-signaling).
The no form of the command reverts to the default value.
This command is supported only when VCB is operating in vcb-branch-initiate mode.
Default 0 (for Mu-Law companding)
13 (for A-Law companding)
To Next Page
Loading...
