Nokia 7705 SAR - Page 530

7705 SAR Interfaces
530
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
3.14.2.1.1 Show APS Commands
aps
Syntax aps [aps-id] [detail]
Context show
Description This command displays Automatic Protection Switching (APS) information.
Parameters aps-id — displays information for the specified APS group ID
Values 1 to 128
detail — displays detailed APS information
Output The following outputs are examples of APS information, and Table 31 describes the fields.
Output Example
*A:7705:Dut-A>config>port# show aps
===============================================================================
APS Group Info
===============================================================================
Interface Admin Oper MC-Ctl Work Prot Active Tx/Rx
State State State Circuit Circuit Circuit K1 Byte
-------------------------------------------------------------------------------
aps-1 Up Up N/A 1/5/1 1/6/1 1/5/1 PC-Tx: No-Req
===============================================================================
*A:7705:Dut-A>config>port# show aps detail
===============================================================================
APS Group: aps-1
===============================================================================
Description : APS Group
Group Id : 1 Active Circuit : 1/5/1
Admin Status : Up Oper Status : Up
Working Circuit : 1/5/1 Protection Circuit : 1/6/1
Switching-mode : Bi-directional Switching-arch : 1+1(sig,data)
Revertive-mode : Non-revertive Revert-time (min) :
Rx K1/K2 byte : 0x00/0x05 (No-Req on Protect)
Tx K1/K2 byte : 0x00/0x05 (No-Req on Protect)
Current APS Status : OK
Multi-Chassis APS : No
Neighbor : 0.0.0.0
Control link state : N/A
Mode mismatch Cnt : 0 Channel mismatch Cnt : 0
PSB failure Cnt : 1 FEPL failure Cnt : 1
-------------------------------------------------------------------------------
APS Working Circuit - 1/5/1
-------------------------------------------------------------------------------
Admin Status : Up Oper Status : Up
Current APS Status : OK No. of Switchovers : 0
Last Switchover : None Switchover seconds : 0