Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 531
Signal Degrade Cnt : 1 Signal Failure Cnt : 0
Last Switch Cmd : No Cmd Last Exercise Result : Unknown
Tx L-AIS : None
-------------------------------------------------------------------------------
APS Protection Circuit - 1/6/1
-------------------------------------------------------------------------------
Admin Status : Up Oper Status : Up
Current APS Status : OK No. of Switchovers : 0
Last Switchover : None Switchover seconds : 0
Signal Degrade Cnt : 1 Signal Failure Cnt : 0
Last Switch Cmd : No Cmd Last Exercise Result : Unknown
Tx L-AIS : None
===============================================================================
Table 31 Show APS Output Fields
Label Description
Interface Specifies the APS interface name (the APS
group port)
Admin State Specifies whether the APS interface is
administratively up or down
Oper State Specifies whether the APS interface is
operationally up or down
MC-Ctl state Specifies the multi-chassis state
Work Circuit Specifies the physical port that is acting as
the working circuit for this APS group
Prot Circuit Specifies the physical port that is acting as
the protection circuit for this APS group
Active Circuit Specifies the active circuit
Tx/Rx K1 Byte Displays the value of the SONET/SDH K1
byte received or transmitted on the protection
circuit
APS Group Displays the APS group name
Description Displays the APS group description
Group ID Displays the APS group ID number
Active Circuit Specifies the physical port that is acting as
the active circuit for this APS group
Admin Status Specifies whether the APS circuit is
administratively up or down
Oper Status Specifies whether the APS circuit is
operationally up or down
To Next Page
Loading...
