7705 SAR Interfaces
532
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Working Circuit Displays the physical port that is acting as the
working circuit for this APS group
Protection Circuit Displays the physical port that is acting as the
protection circuit for this APS group
Switching-mode Displays the switching mode of the APS
group
Switching-arch Displays the architecture of the APS group
Revertive-mode Displays the revertive mode of the APS
group:
non-revertive — traffic remains on the
protection line until another switch request is
received
revertive — when the condition that caused a
switch to the protection line has been
cleared, the signal is switched back to the
working line
Revert-time Displays the configured time, in minutes, to
wait after the working circuit has become
functional again before making the working
circuit active again. If the revertive mode is
non-revertive, then this field is empty.
Rx K1/K2 byte Displays the value of the SONET/SDH K1/K2
byte received on the interface
Tx K1/K2 byte Displays the value of the SONET/SDH K1/K2
byte transmitted on the interface
Current APS Status Displays the current APS status
Multi-Chassis APS Indicates whether MC-APS is configured
Neighbor Displays the neighbor IP address. All zeros
indicates the APS group is an SC-APS.
Control link state Displays the current control link status
Mode mismatch Cnt Indicates the number of times a conflict
occurs between the current local mode and
the received K2 mode information
Channel mismatch Cnt Indicates the number of mismatches
between the transmitted K1 channel and the
received K2 channel that have been detected
Table 31 Show APS Output Fields (Continued)
Label Description
To Next Page
Loading...
